Common Kitchen Countertop Problems That Should Be Repaired?

Here are some of the most typical problems that contractors encounter as they install kitchen countertops that need to be fixed right away: 

If the walls aren’t horizontal or vertical as they are supposed to be, mount the countertop as planned and then correct or fill the wall surface with other products or plaster additive. Make sure to secure the countertop using a heavy polyethylene plastic wrap.  

Wrong design— 

When it comes to kitchen remodeling, having the wrong design is one of the most common issues. Occasionally, once the old kitchen cabinets and countertop have not been eliminated or when you’ve incorporated walls in the new layout, incorrect measurements can cause tons of issues such as horizontal or vertical surfaces not long, short, or flat countertops, incorrect angles or perhaps you never planned to have the new countertop into the planned location. If you encounter these, they can be a total headache especially if you do not know how to manage it. 

Rupture backsplash  

The countertop backsplash can simply be harmed if it’s being carried to be installed. To resolve this issue, do not throw away the broken part. Instead, keep it and have it glued to the surface of the countertop. Utilize the recommended glue. Then, use sandpapers to polish the new joint.  

Crack on the edge of appliance or fixture 

Normally, the cracking issue is due to a poor installation without the needed support under the countertop. This could take place in the sink, front of the stove, or in massive unsupported spaces of your kitchen countertop. To avoid this, make sure that the cabinet where the stove will be positioned has openings to help dissipate heat. Moreover, guarantee to inspect whether that extra supports have been setup below such areas and ensure that long unsupported places have extra reinforcements below the countertop. 

Rupture kitchen countertop 

When a kitchen countertop is either poorly installed, installed on top of an unleveled surface, or when the glue wasn’t allowed to dry, it leads to a rupture countertop. This usually happens as well if it’s subjected to very high loads with not enough support underneath it or on top of a small countertop surface, particularly that small space in front of the sink.  

Water or sink leakage 

If the sink has not been sealed and installed property over the joint, then there’s a possibility that the water will reach inside your kitchen cabinets, which can damage them eventually.  Make sure to thoroughly inspect the drainage pipe and whether the sink was properly sealed with silicon all over the joint and sink. Moreover, check the dimensions where the hot and cold water supply lines are positioned. This way, you can plan in advance and have the proper openings for these water pipes. When you get the incorrect measurements, you can transport a router and create oval openings, which enables the rough-in to be positioned. If you’re not confident doing this yourself, feel free to contact a kitchen countertop repair Red Deer specialist today.  

Leave a Reply

Your email address will not be published.